Mylee Crème Wax - Tea Tree

Product Code: MYLW02

STEP 1. HEAT
Place your Mylee Crème Wax pot directly into the Mylee Wax Heater* (remove the Mylee Silicone Jar if using the Mylee Digital Wax Heater or the Metal Pot if you’re using the Mylee Professional Wax Heater*). Allow the wax to melt to a smooth, spreadable consistency. Always test the temperature on the inside of your wrist - it should feel warm, never hot or uncomfortable.

STEP 2. PREP
Apply Mylee Pre Care Gel* to the area using a cotton pad* or clean hands to remove oil, makeup and impurities. Allow the skin to dry fully before waxing.

STEP 3. APPLY & REMOVE
Using a Mylee Disposable Spatula*, spread a thin, even layer of Mylee Crème Wax in the direction of hair growth. Work in small sections for best results. Immediately place a Mylee Paper Waxing Strip* over the wax, smoothing it down firmly. Hold the skin taut, then remove the strip in one quick motion against the direction of hair growth. Avoid waxing the same area more than twice.

STEP 4. FINISH & CARE
Apply Mylee Pre & Post Wax Oil* to remove any residue and help nourish the skin. 

*Products sold separately.

Mastering the Mylee Advanced Stripless Wax is all about that "cool and pull" technique.

• Getting the temp right is everything. You want your wax to look like thick, gooey honey - not runny water!
  Melt your wax using a high heat for about 15-20 minutes, then turn the dial down to medium. Our Digital wax Heater does this for you automatically! If the wax runs off your spatula instantly, it’s too hot. Let it sit for a minute until it stays on the stick for a few seconds when you twirl it.

• When you apply your wax in a strip, make sure the very end (where there is no hair) is a little bit thicker than the rest. This creates a "pull tab" or lip. It means you can get a firm grip and flick it back without having to pick at the edge.
  
• Don't be shy with that spatula! If you apply the wax too lightly, it won't "shrink-wrap" the hair.
  
• Use firm, even pressure when spreading the wax in the direction of hair growth. You want to really push the wax into the hair follicles so it grabs every single strand from the root.
  
• Hold the skin as taut as possible. When you pull the wax off, keep your hand parallel and close to the skin, pulling back in the opposite direction of growth. Think of it as a "flick" rather than a "lift" - it’s faster, smoother, and way less "ouchy."
  
• As soon as you’ve pulled the wax strip off, immediately press your palm firmly onto the skin for a few seconds. The pressure confuses your nerves and stops the "sting" before it even starts. Total game-changer!
  
• Use the Mylee Silicone Bucket for your beads. Once you’re finished and the wax has cooled completely, just "pop" the hardened wax disc out. You can save it for your next session or wipe the bucket clean in seconds. No mess, no stress.

Glyceryl Rosinate, Paraffinum Liquidum (Mineral Oil), Titanium Dioxide, Melaleuca Alternifolia (Tea Tree) Leaf Oil, Pinene, Terpinolene, CI 61565 [Green 6], CI 47000 [Yellow 11].